Publicidad
Idiomas disponibles
Idiomas disponibles
3. REAR VIEW
1) Power supply input 100-240Vac 50/60 Hz. It allows the
connection of the device to the mains by means of the
supplied cable (CEE7 Male / C13 Female, 1.8m).
2) Mains power fuse (1A). There is a spare fuse inside the
same box.
3) Grounding.
4) RESET button. Clears the settings and restores the default
network address:
IP ADDRESS: 10.1.1.1.1
NETMASK: 255.0.0.0.0
GATETEWAY: 0.0.0.0.0 (no Gateway)
To do this, press and hold it for 10 seconds with the unit
turned on (the front STREAMING indicators will blink 4
times at the end of the process).
5) CONSOLE connector. Mini USB connector. Allows to
monitor the system. Specialized personnel only.
6) ETH A connector. Used to connect the device to the IP
network.
(6a) LINK indicator (yellow LED):
Indicates connection to the network.
(6b) ACTIVITY indicator (green LED):
Flashing indicates sending or receiving data.
MI2-700ETH 5.2.002 version
MI2-700ETH
Figure 2
7) ETH B connector. Used, in a redundant network, as a
8) "L" and "R" connectors of the Channel 1 music input. For
9) "L" and "R" connectors of the Channel 2 music input. For
10) Music control input contacts. They allow to activate or
Converter of 2 analogue audio signals
to 2 channels of streaming via IP
secondary connection to the IP network.
their connection see section 5.4.
connection see section 5.4.
deactivate the music of each channel. Activation can be
configured by pulse or by level using the Call Point or Call
Point Configurator software. For their connection see
section 5.5.
COM. Common.
CH1 ACTIVATION. Activates music channel 1.
CH2 ACTIVATION. Activates music channel 2.
R+D Department
5
Publicidad
