Blackstone 1867 Manual Del Propietário página 5

through each burner tube
several times� (do NoT use
wire brushes)
Model: 1867
• Run a stiff wire bent into a small
hook through each burner tube
several times�
• Use compressed air to blow
ASSeMBlY INSTRUCTIoNS
through the burner tube and
out the burner ports� Check that
Find a large, clean area to assemble your appliance�
air blows through each hole�
Remove all packing material before assembling�
(Wear eye protection)
Brush entire
STEP 04
TOOLS NEEDED:
Sharp edges. Wear gloves while assembling.
outer surface of burner to
Phillips head screwdriver &
remove grime�
Adjustable wrench
Remove the griddle body from the packaging� Take the
STEP 01
griddle top off and set aside� Clean any blocked ports
STEP 05
with stiff wire such as an open
Place the griddle on its back� Use four (4) M8 flange nuts to attach
paper clip�
four (4) griddle feet to the bottom of the griddle�
ensure that the fuel nozzle is housed within the burner opening�
Carefully replace burners
STEP 06
and reattach�
The gas rail fuel nozzle
must be reengaged within the
burner opening�
NOT INCLUDED:
lPG cylinder
Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
Align heat shield with griddle body holes�
STEP 03
lPG cylinder must include collar to lPG cylinder must include collar to
protect lPG cylinder valve. protect lPG cylinder valve.
Slide the grease cup into the drawer on the front of
STEP 05
NOT INCLUDED:
the griddle�
17" griddle base
Heavy pieces. Two people should assemble this appliance.
BLACKSTONEPRODUCTS.COM/SUPPORT
CAUTIoN
TOOL NEEDED:
Phillips head screwdriver
Fuel nozzle Fuel nozzle
Burner opening Burner opening
NOT INCLUDED:
lPG cylinder
Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
NOT INCLUDED:
22" griddle base
CAUTIoN
ASSEMBLY GUIDE
TOOL NEEDED:
Adjustable wrench
Set the griddle on its feet� ensure that the ignition needle is
STEP 02
set 3-7mm above the burner tube�
NOT INCLUDED:
AA battery
Place the griddle top on the main body by aligning the 4 pins
STEP 04
to the holes of the body� Make sure that all four (4) pins are seated in
the holes�
Proceed to USING YOUR BLACKSTONE�
STEP 06
NOTICE
Place appliance on a heat-resistant and flame-resistant
surface while in use.
| OWNER'S MANUAL
TOOL NEEDED:
5mm Allen wrench
3-7mm 3-7mm
NOT INCLUDED:
AAA battery
ELECTRIC REQUIREMENTS:
120V 60Hz
05