Publicidad
Idiomas disponibles
Idiomas disponibles
5. Manual Override MODE (nighttime operation only)
●
To shift to the manual override mode, set the switch to "AUTO" or
"OFF" mode. Turn the wall switch "OFF" and "ON" within 3 seconds.
The light will remain on until dawn. To restore to the "AUTO" or "OFF"
mode, turn the wall switch "OFF" and "ON" within 3 seconds.
(See Fig.1)
●
The light will last for one night only and turn off automatically at dawn.
Customization Options
Shut-off Delay
1. The Shut-off delay is the length of time that the light will stay on
after motion stops.
2. The Shut-off delay can be adjusted by using the "TIME" knob when
the slide switch is set in "OFF" or "AUTO" mode. (See Fig.2)
3. The range of shut-off delay is 5 seconds to 3 minutes.
4. Rotate the knob clockwise for increasing the shut-off delay.
5. Rotate the knob counterclockwise for decreasing the shut-off delay.
Sensitivity of Motion Sensor
1. The sensitivity can be adjusted from 5 to 30 feet by using the "SENSITIVITY" knob. (See Fig.2).
2. Turn the knob clockwise for increased sensitivity.
3. Turn the knob counterclockwise for decreased sensitivity.
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets colder. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
ensure maximum sensitivity.
2. When installed at a height of 6.5 feet, at 77 degrees Fahrenheit,
the light will provide a maximum detection distance of 30 feet
and detection range of 150 degrees. (See Fig.3, Fig.4)
3. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.5)
4. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
TROUBLESHOOTING
Refer to following information to solve your problems.
DAY/NIGHT
SYMPTOM
Day
If the light
isn't on
Night
POSSIBLE CAUSE
Rotary knob is not set in the test
mode.
Wall switch or circuit breaker is off.
Light bulb may be burned out.
Light bulb is loose.
Incorrect or loose wire connections.
Too much sunlight is shining onto
sensor in the early evening.
Too much light is shining onto
sensor due to another light source,
such as a street lamp or other light
fixture.
Page 3 / 4
Fig.1
Turn wall switch OFF-ON
in 0.5~3 Seconds
Auto Mode
Off Mode
Turn wall switch OFF-ON
in 0.5~3 Seconds
Fig. 2
(View from bottom of sensor lens)
5S
3MIN
TEST
TIME
Where you install your lantern is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
Fig. 3
10`
6`
5`
30`
Fig. 5
Motion
Sensor
Least sensitivity
SOLUTION
Set the rotary knob in the test mode for testing.
Turn on wall switch or circuit breaker.
Test the light bulb on normal working light fixture.
Tighten the light bulb.
Check wire connections.
Relocate fixture away from western facing wall.
Eliminate or turn off other light source, block other
light source from shining onto sensor, or relocate
fixture.
Manual
Override
OFF AUTO PC SENSITIVITY
Mode
Fig. 4
150˚
Motion
Most sensitivity
231011
Publicidad
