Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING (continued)
SYMPTOM
DAY/NIGHT
Day
If the light
stays on
Night
If the light
Night
is blinking
The light
comes on for
Night
no apparent
reason
The following parts are available for reorder if damaged or missing.
Spare Parts List:
Mounting Plate Unit (A)
Mounting Screw (B) Wire Connector (C) Bolt Nut (D)
Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.
In addition:
● Any product with an integrated motion sensor or dusk-to-dawn photocell is supported by a 5-year warranty for the
functionality of the product.
● Any product with integrated LED modules is covered by a 5-year warranty on the LED functionality.
Exclusions: This warranty does not include the failure of products from extreme acts of nature; environmental conditions
not suited for the products intended use; operation in temperatures outside of the range specified in the instruction manual;
usage with improper power supply, power surges or dips. For coastal locations, some corrosion is considered normal for
the environment.
Vaxcel reserves the right to repair, replace or issue a credit for any properly installed product, provided it is returned per
RMA instruction. This warranty is limited to the cost of the product only and does not extend to transportation, installation
or replacement costs.
POSSIBLE CAUSE
The fixture may be installed in
shaded area.
On cloudy or overcast days, the light
may stay on longer than anticipated.
Still on the manual override mode.
False triggering caused by a heat
source, such as a heater, dryer vent,
or heated swimming pool.
The knob is not set in any mode.
Passing cars and reflective objects
interfere with the sensor.
Street or sidewalk traffic is triggering
motion sensor.
False triggering caused by a heat
source, such as a heater, dryer vent,
or heated swimming pool.
Assembly Kit
6760MM (1 SET) for T0734
6761MM (1 SET) for T0735
5 Year Limited Warranty
How can warranty service be obtained?
info@vaxcel.com
1-800-482-9235
Page 4 / 4
SOLUTION
Only need to relocate fixture.
No corrective action needed.
Turn off the light, then turn it on after 5 seconds.
Eliminate heat source or relocate fixture.
Rotate it again to the mode you want.
Relocate fixture.
Adjust the "Sens" knob to reduce the sensitivity.
Eliminate heat source or relocate fixture.
A
Rubber Pad (E)
A: 17-3/4"
B: 6-1/2"
C: 7"
C
B
231011
Publicidad
