Zycoo BM11 Guía De Instalación Rápida página 3

Mechanical Installation
1
Use an 8 mm drill to drill 4 mounting holes on the wall with 57 (H) x 43 (W) spacing, each
hole should be able to fit M6*25mm anchor.
2
Push the 4 anchors into each of the mounting holes with a rubber hammer.
3
Unscrew and remove the front panel from the SIP safety intercom using the L-shaped
screwdriver.
4
Connect the connecting wire through the guard coil to the connector terminal as shown in
the connection diagram below.
5
Install the front panel onto the rear panel box and tighten the screws using the L-shaped
screwdriver.
SW15
RST
1
English
SC15
ETH0
SYS
ETH0
SYS
RST
BM11