Gear Selection; Magnet Detection - Walter ICECUT300 Manual De Instrucciones

10) GEAR SELECTION

ICECUT 300
The ICECUT 300 magnetic drill is fitted with a 2 speed gearbox. The gear is used to reduce the output speed when
using larger cutters.
Slide Selector Position
°
/\
\/
ICECUT 400
The ICECUT 400 magnetic drill is fitted with a 4 speed gearbox. The gear is used to reduce the output speed when
using larger cutters.
Slide Selector Position
Left Right
\/
\/
/\
/\
Slide Selector Positon Left
The Slide Selector Positions show Left /\ and Right\/depicting an available range of 240 – 700/min.

11) MAGNET DETECTION

It is advised that when working on thin material a packing piece should be used to increase the material thickness
under the magnet. Working on thin material without a packing piece will reduce the magnet holding force.
It is advised that the drill is to be operated on ferrous material 12mm thick and above. Damage to the magnet base,
such as pitting, will affect the strength of the magnet holding force.
Speed Controller Setting
Level 1
200/min
70/min
Speed Controller Setting
Level 1
/\ 45/min
70/min
\/
/\ 150/min
240/min
\/
Level 6
500/min
180/min
Level 6
129/min
208/min
434/min
700/min
Slide Selector Position Right
12