Publicidad
Idiomas disponibles
Idiomas disponibles
interfering wires in an area. Make sure your receiver is selected to the
same mode as the transmitter. If not, the locator will not work
correctly.
WARNING – Do not touch the metal portion of the red or black
alligator clips on the transmitter cords when the power is on. There
is a danger of injury or death should this occur.
Receiver Operation – Turn on your receiver by turning the volume
control clockwise. Once again, battery condition is indicated by the
light directly above the power dial (light off = good battery, light on =
low battery).
Tracing Wire – After the transmitter has been properly connected and
verified to have a good ground and power set, turn on the receiving
wand. The receiver defaults to the most recently used mode with null
antenna reception at every start-up. Place the receiver near the
6
Publicidad
