Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Won't Fill
Won't Agitate
Won't Spin or Drain
Load is Wet
Stops
Plug cord into live electrical
outlet.
Check fuse or reset circuit breaker.
Turn the control knob to proper cycle and pull knob out to start the washer.
Turn both faucets on fully.
Straighten
inlet hoses.
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Check fuse or reset circuit breaker.
Make sure the lid is completely
closed.
Turn the control knob to proper cycle and pull knob out to start the washer.
Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless the lid is closed.
The washer is equipped with a lid switch failure detector. If the lid switch should
malfunction,
the detector will stop operations
for your safety. Call for service.
• Unevenly distributed
load. Redistribute
the load, close the lid and pull knob out.
Check for leveling. Be sure water level is acceptable
for load size.
• Check fuse or reset circuit breaker.
• Straighten
drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for
service.
• Close lid and pull knob out to start the washer. For your safety, washer will not spin
unless lid is closed.
• The washer is equipped with a lid switch failure detector. If the lid switch should
malfunction,
the detector will stop operations
for your safety. Call for service.
• Suds lock - caused by too much suds. Rewash without
detergent.
Use correct
amount of a low-sudsing
detergent.
The washer may have sensed an unevenly distributed
load. Redistribute
the load in
the tub, close the lid and pull the control knob out.
A normal spin speed is recommended
for heavy loads like jeans or towels.
Unevenly distributed
load. Redistribute
the load, close the lid and pull knob out.
Check for leveling. Be sure water level is acceptable
for load size.
• Plug cord into live electrical
outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer is equipped with a lid switch failure detector. If the lid switch should
malfunction,
the detector will stop fill operations
for your safety. Call for service.
Publicidad
