Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Leaks Water
Is Noisy
Fills with the Wrong
Temperature
Water
• Make sure hose connections
are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended soaking - soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined
in installation
manual.
• Weak floors can cause vibration
and walking.
• Be sure rubber feet are installed on leveling legs.
• Operating
sounds will vary depending
on agitation speed.
• Turn both faucets on fully.
• If equipped with a temperature
selector knob, be sure it is set directly on a
temperature
setting and not between settings.
• Make sure temperature
selection
is correct.
• Make sure hoses are connected
to correct faucets and inlet connections.
Be sure
water supply is regulated
correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum
120° F (49 ° C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Disconnect
hoses and clean screens. Hose filter screens may be plugged.
10
Publicidad
