Husqvarna ECA308 Manual Del Usuario página 12

Note:
hand thread.
3. Remove the support flange (D), retainer
(C), blade (B) and drive disc (A).
4. Examine the locknut, support flange,
retainer and drive disc. Replace any
damaged parts.
5. Attach the drive disc on the output shaft.
Make sure that the outer edge of the drive
disk is in hole of the blade.
C
D
E
Weight
Weight, lb/kg
Cutting equipment
Blade
12
The locknut has a left-
F
A
B
Technical data
Accessories
6. Install the new blade on the drive disc.
7. Install the support flange. The outer edge
of the support flange must push on the
blade.
8. Install the support flange.
9. Install the locknut.
10.Tighten the locknut to a torque of 12-15
ft-lb / 15-20 Nm.
11.Remove the screwdriver or locking pin.
ECA308
4.9/2.2
Art. no.
531 30 02-33
2105 - 001 - 07.08.2023