Makita 3601B Manual De Instrucciones página 6

To install the straight guide, insert the guide bar into
the holes in the tool base until the notch in the guide
bar reaches just under the wing bolt (B). Then tighten
wing bolt (B). Loosen the wing bolt (A) and adjust the
distance between the bit and the straight guide. At the
desired distance, tighten the wing bolt (A) to secure the
straight guide in place.
1
3
► 1. Wing bolt (B) 2. Wing bolt (A) 3. Straight guide
4. Guide bar
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
Templet guide (optional accessory)
The templet guide provides a sleeve through which
the bit passes, allowing use of the tool with templet
patterns.
To install the templet guide, screw the templet guide on
the base plate.
1
► 1. Base plate 2. Templet guide
2
4
2
3
4
► 1. Bit 2. Base 3. Templet 4. Workpiece 5. Distance
(X) 6. Outside diameter of the templet guide
7. Templet guide
NOTE:
• The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by
using the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Trimmer guide (optional accessory)
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the wing
bolts (B). Loosen the wing bolt (A) and adjust the dis-
tance between the bit and the trimmer guide by turning
the fine adjusting screw (1.5 mm or about 1/16" per
turn). At the desired distance, tighten the wing bolt (A)
to secure the trimmer guide in place. When adjusting
the guide roller up or down, loosen the wing bolt (C).
After adjusting it, tighten the wing bolt (C) securely.
2
6 ENGLISH
1
7
5
6