Emos THS916A Manual Del Usuario página 8

The acoustic and optical alarm during testing is only used as indication that the detector is operational.
It does not mean that a fire has been detected.
FAULT STATE
If the detector is in fault state, it is not functional.
Fault state is indicated by 1× beep every 40 seconds.
Immediately replace the battery and check that the detector is undamaged; clean the openings of
the detector using, for instance, a vacuum cleaner. Do a function test.
If the fault state persists even after the battery has been replaced, contact the service centre.
LOW BATTERY
A low battery in the detector is indicated by a single beep and a flash of the red LED simultane-
ously every 40 s at least 30 days before the battery runs out. Immediately replace the battery.
Use alkaline batteries only; do not use rechargeable batteries.
Do a function test.
It is recommended to replace the battery 1× a year as a precaution.
END OF LIFE OF THE DETECTOR
The detector has a service life of 10 years since production.
After expiration, the detector must no longer be used and must be replaced with a new device.
The replacement date for the detector is listed on the label on the back, next to „Replace device".
If you are using multiple detectors, remember to check their replacement dates!
ALARM WARNING
If a fire is detected, the detector will start emitting an acoustic + optical signal.
The detector will beep and the red LED will flash 3× in a row (followed by a 1.5 second pause).
The alarm will be active until the air clears.
The acoustic signal of the alarm can be temporarily silenced by pressing the TEST button.
The acoustic signal will be silenced for 8 minutes; the red LED will flash every 40 seconds.
After 8 minutes, the acoustic signal will reactivate until the air clears.
If an alarm triggers, immediately evacuate the building and make sure all other people have left as well.
Do not stop to call in help or gather your belongings.
Contact the corresponding emergency service.
Wait until the air clears.
Do not remove or disconnect the battery to silence the alarm – that deactivates the detector!
Overview of Possible Fault States of the Detector
State
Test mode not functioning.
Alarm indication by a simultaneous 1× beep/
1× flash of the red LED.
The alarm beeps every 40 seconds
(the detector is in fault mode).
The device randomly emits a different alert
sound than usual.
Solution
1. Check that the battery is connected
correctly.
2. If the fault persists, return the device.
1. The battery is low, replace it.
1. Clean the detector.
2. Return the device or replace it with a new
one.
1. Clean the detector.
2. Relocate the detector.
3. Return the device or replace it with a new
one.
8