Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THEAIRFILTER
Adirty airfilter w illreduce t hecompressor's
performance
and
life. T oavoid anyinternal contamination
ofthepump, thefilter
should b ecleaned frequently, andreplaced ona regular basis.
Felt f ilters should b ecleaned inwarm, soapy w ater, rinsed, and
allowed t oairdrybefore reinstaltation.
Paper filters should be
replaced when dirty. D onotallow thefilter t obecome filled with
dirtorpaint. I fthefilter becomes filled withpaint, itshould b e
replaced. Direct exposure todirty conditions orpainting areas w ilt
void your w arranty.
CHECKING THE RELIEF VALVE
Pull the tank safety valve daily to ensure that it is operating
properly and to clear the valve of any possible obstructions.
TESTING FOR LEAKS
Check that all connections are tight. A small leak in any of
the hoses, transfer tubes, or pipe connections will substantially
reduce the performance of your air compressor. If you suspect a
leak, spray a small amount of soapy water around the area of the
suspected leak with a spray bottle. If bubbles appear, repair or
replace the faulty component. Do not over tighten any
connections.
STORAGE
Before storing the compressor for a prolonged period, use an
air blow gun to clean all dust and debris from the compressor.
Disconnect the power cord and coil it up. Pull the tank safety
valve to release all pressure from the tank. Drain all moisture
from the tank. Clean the filter element and filter housing; replace
the element if necessary. Drain the oil from the pump crankcase
and replace it with new oil. Cover the entire unit to protect it from
moisture and dust.
Daily or after
Every 100
Perform the following
maintenance
at the intervals indicated below,
each use
operating hours
Inspect air filter (clean or replace as necessary)
•
Check pump oil level
•
Change pump oil (Use synthetic, non-detergent
air compressor oil)
•
Operate the tank safety valve
•
Check belt tension
•
Drain tank
•
Check and tighten all bolts (do not over tighten)
•
200-2794
11
Publicidad
