Samsung SCC-C7433P Guia Del Usuario página 25

. Prepare the Holder Housing part. Refer to the wiring diagram below to connect the external
cables and the cables of the Holder Housing.
A. Remove one of the connectors connected to the cable end of the Holder Housing.
B. Peel off the coating of the cable and connect it to the external cable using soldering/
(See page 17 in the installation guide to Connect the cables.)
C. Use an insulation tape to wrap up the soldering portion of two cables.
D. Connect the Connector to the Holder Housing again.
E. Repeat the above steps to connect all of the 4 Connectors to the appropriate external cables.
F. In the last step, connect the BNC jack.
CONNECTOR
CABLE
HOLDER HOUSING
HOLDER HOUSING
External Cable
ROD COUPLING
Soldering
CONNECTOR
HOLDER HOUSING