Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the unit
Setting up the receiver
Tuning the aerial
Connecting the AF-/headphone output
Insert the telescopic antenna in the jack and
Retract the aerial with the station turned on until
extend to full length.
the peak RF ® is indicated.
Notes:
• Do not locate the recewer near digitally control¬
led units.
• Locate the receiver in the same room as the
transmitter.
• Locate the receiver at the highest point possi
ble, so that the antenna has an 'unobstructed
view" of the transmitter.
Futher information can be found in the section
concerning 'Connecting and setting up detached
antennas'.
AF output
The AF signal (balanced, floating) is located at
jack®.
Technical specifications:
Plug connection:
Impedance:
Rated load:
Output voltage at
rated/peak swing:
XLR plug, floating
approx. 20 ohms
^ 600 ohms
3 V = + 12 dBm/
6 V = + 18 dBm,
adjustable
Headphone output
For monitoring purposes you may conncect
stereo headphones at headphone jack 0) (e. g.
HD 250 linear).
Technical specifications:
Plug connection:
Rated load:
Output voltage at
rated swing:
6,3 mm 0 jack
£ 50 ohms
3 V ± 2 dB,
adjustable
14
15
Publicidad
