Hitachi HT-66S Manual Del Usuario página 8

Interrupting disk play (auto-cut)
START/CUT
ree
M@ Temporary play suspension Timer play
"Wake-up disk play'' can be performed if a timer is
used in combination with your unit.
(1) Set the POWER switch@) to ON (2).
(2) Depress the UP/DOWN switch@) and cause the
tonearm @ to rise.
(3) Move the tonearm (4 over the disk.
(4) Set the timer and the amplifier.
Depress the UP/DOWN swit-
ch@). The stylus rises gently
from the disk and play is inter-
rupted.
CAUTION
Timer play is possible only for 30 cm, 33-1/3 rpm
and 17 cm, 45 rpm disks.
When play resumes,
depress
s
resumes from virtually the
same position as when play
was Suspended.
CAUTION
Except when suspending play, keep the tonearm
(to the DOWN position.
OPERATING PRECAUTIONS
* Detaching and replacing the dust cover e Howling
The dust cover can easily be detached and replaced.
Cartridges are very sensitive and may pick up slight
To detach, raise the dust cover, pull out the dust
sound pressure or vibrations of the speaker coming
cover from the cabinet together with the hinges.
along the floor or through the air — resulting in howl-
To replace, follow the same procedure in reverse.
ing. Therefore, the location of your turntable is very
important. Find a location which is very stable and
free from vibration or close the dust cover if it is
open, or carry through both measures.
Induction Hum
Your turntable utilizes a brushless DC servo motor to
reduce inductive hum. If annoying inductive hum is
heard, it can be caused by the electromagnetic field
produced from the motors or transformers used in
another device. Do not place the turntable near a
device in which a motor or transformer is
used. To prevent the turntable from being affected
by the power transformer of your amplifier, receiver
or tape deck, position the turntable on the opposite
side of the power transformer.
Simultaneous use of tuner and turntable
Do not use the turntable while the tuner is receiving a
program since this will result in interference.
Dust cover