dirna Bergstrom TRP COMPACT N&D Manual Del Usuario página 23

COMPACT N&D
• Reprogram control.
• Replace control's battery and reprogram.
• Replace electronic control.
• Replace control.
!
(If the error persists contact an Authorised Service Centre).
• Disassemble the internal air distribution panel and correctly connect the cable of
the control panel and electronic control.
• Place the device at less than 45° tilt (The device must not operate with a tilt of 45
degrees or more to prevent damage to the compressor). The electronic control
detects the tilt so it should also be at less than 45°.
• Clear the obstruction from the drainage pipe and valve (For access you must
remove the device's external cover).
• Replace the EPDM seal (you must disassemble the device and thoroughly clean
the surface where the EPDM seal will be stuck).
• Seal the cabling outlet on the cover of the compartment of the evaporator and
centrifugal blower (For access you must removed the device's external cover).
All manuals and user guides at all-guides.com
Solution
23
EN
®