Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the Clock
The clock has a 12-hour digital indication.
For example, set it to 10:08.
1 Turn the ignition key to the ON position.
2 Press the DSPL/CLOCK SET button for
more than two seconds.
=f Vt?
5
TTA
The indication starts flashing.
3 Press the Ge) (>) to set the hour
digits.
$
5
(to go back)
(to go forward)
Press the («
») to set the minute
digits.
(to go back)
(to go forward)
AVI TY
100
y
MEENE
MM
faye
4 press the DSPL/CLOCK SET button.
The clock is activated.
Note
When the POWER SELECT switch on the hideaway unit
is set to the "OFF" position, the clock display will not come
on the display unit even if the ignition of your car is
turned on. In such a case, press the POWER switch of the
display unit and playa disc. Then follow steps 2 to 4.
Changing the Transmitting
Frequency
You can select the frequency of the modulated
RF signal being transmitted from the hideaway
unit according to the level of interference
noise.
ENTER
1 Press the ENTER/DELETE button for more
than two seconds.
The system will enter the frequency
selecting mode. The initial setting is
88.3 MHz.
2 Press either the E) or (+) to select the
frequency.
At each pressing, the buttons will change
the frequency as follows:
(=) : 88.3 MHz — 89.9 MHz — 89.7 MHz 一
88.7 MHz — 88.3 MHz
: 88.3 MHz — 88.7 MHz 一 89.7 MHz —
89.9 MHz — 88.3 MHz
3 Press the ENTER/DELETE button again for
more than two seconds.
Note
Be sure to set the frequency of your FM tuner to that of the
newly selected frequency.
Publicidad
