GET SX1 PRO 4T Guia página 11

PROCEDURE
1.
Remove
protective
connect the RESET TPS
cable (included in the box)
to SX1 PRO ECU"MAIN"
connector.
2.
Enable the LATCH
MODE function. Connect
a fully charged
battery to the "RESET
TPS" cable: first, connect
the red wire to the
positive (+) pole and then
connect the black wire to
the negative (-) pole.
3.
Twist the throttle
completely forward to
make sure it is in closed
position
operation.
hold the engine stop
button for 5 seconds or
until the SX1- turns the
fuel pump and the MIL
(Malfunction
Lamp) light on (when
present). By doing this
operation, the minimum
TPS value is saved.
the
caps and
12V
during this
Press and
Indicator
2
11
1
5 sec.
EN