West Bend HANDMIXERPLUS Manual De Instrucciones página 5

1. Remove any packaging materials.
Warning: Blades are very sharp, handle with care.
2. Wash all accessories in hot soapy water. Rinse and dry thoroughly.
3. Before assembling the mixer, ensure the power cord is unplugged from the power outlet
and the speed selector is at the "0" position.
WARNING: Do not put metal utensils (knives, spoons, forks, etc.) into the bowl while
operating the mixer.
NOTE: Do not let the unit come into contact with acidic foods.
1. Insert the correct attachment(s) based on mixing/blending needs.
• The beaters are identical and can be inserted into either drive hole.
• Unlike the beaters, the dough hooks are not interchangeable. When using the dough
hooks, insert the one with the washer into the larger drive hole, and the one without the
washer into the smaller drive hole.
2. With the correct accessory attached, turn the speed selector to the "0" OFF position, then
plug the power cord into the wall outlet.
3. When mixing, to avoid splatters, start the unit on the lowest speed and slowly increase to
the desired speed setting.
4. Slowly guide the mixer around the sides and through the center of the bowl, going in the
same direction. Be careful not to overbeat the mixture. Overbeating tends to make some
mixtures tough.
5. To increase power during heavy mixing tasks, press the turbo button to drive through the
mixture with ease.
6. When mixing is complete, turn the speed selector to the "0" setting, and unplug the cord
from the power outlet.
7. If necessary, scrape excess food from the attachment using a rubber spatula.
8. To remove dough hooks, beaters or whisk, hold the stems of the attachments fi rmly, then
press the Easy-Release Lever. Attachments will come off.
To use the immersion blender wand:
1. Remove the cap from the base of unit, then place it into the cap holder. (See Fig. 1)
2. Hold the hand mixer in the
upright position, then insert
the immersion blender wand.
Push fi rmly until you hear the
click indicating the wand has
been securely inserted.
3. Always ensure the speed
selector is set to the "0"
position.
4. Press and hold the Turbo button to blend.
5. To stop, simply release the Turbo button.
6. To remove the immersion blender
wand, push the release buttons on both
sides of the unit at the same time. The
immersion blender wand will come off.
(See Fig. 2)
BEFORE USE
USING YOUR HAND MIXER
English - 5
Fig. 1
Fig. 2