Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Controls
The hood is operated using the slide controls
under the bottom d the hood.
The light switch turns the lamps on and off.
The blower switch :makes it possible to select
the motor operating speed. Position 0: motor
off.
The pilot lamp Sightsup whenever the blower
is on.
LIGHT
SWmTCH
PILOT LAMP
BLOWER
SWITCH
HEAT SENTRY
TM
Your hood is equipped with a HEAT SENTRY
TM
thermostat.
This thermostat is a
device that wilt turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature
level drops to normal, the blower will return to its original
setting.
WARNING
The H EAT SENTRY thermostat
can start the blower even if the hood is turned
OFF. When this occurs,
it is impossible
to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical
panel.
HALOGEN
BULBS
This range hood requires two halogen bulbs
(Type GU10, MR16 shielded, 120V, 50W).
ALWAYS
SWITCH OFF THE ELECTRICITY
SUPPLY
BEFORE
CARRYING
OUT ANY
OPERATIONS
ON THE APPLIANCE.
1. Remove the grease filters.
2. Remove the metal grille by turning the (2)
knobs counterclockwise.
3. Loosen
the
ring
nut
by
turning
it
counterclockwise.
4. Loosen
the
bulb
by
turning
it
counterclockwise;
pull the bulb downwards
to remove. CAUTION:
BULB
MAY BE
HOT!
5. Replace with Type GUI0, MR16 shielded,
120V, 50W halogen bulb.
KNOLBGRILLE
BULB
NUT
-9-
Publicidad
