Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Water is not coming out of the wand.
•
Turn the diverter valve to the "on" position.
•
Make sure the tubing is smooth and straight, without kinks.
Water leaks out of between filter cartridges or at the filter inlet assembly or filter
base.
•
Separate the cartridges at the point of the leak. Each of the cartridges, and the filter
inlet, should have two o-rings on the raised outlet found on the bottom of the
cartridge. Check to ensure that the o-rings are in place and properly seated in the
grooves provided for them.
Water leaks from the tubing.
•
Check the tubing for cuts or nicks.
Water continues to flow out of the wand after water is turned off.
•
Water may continue to flow from the wand for a short time due to a build-up of
pressure within the filter. It will typically stop by itself. You may also turn the diverter
valve lever to the off position to activate your tap water faucet, which will reduce
water coming from the wand.
•
Trapped air in the filter may force water out after the tap has been turned off. To
eliminate trapped air, follow the steps listed under the section "CHARGE THE
SYSTEM" - STEP 10.
Indicator Lights (LED) on the base do not work.
•
Replace the old batteries with two new high quality AA batteries.
EN
19
Publicidad
