Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS FOR POWER ADAPTER
Do not expose to rain or snow. Store indoors
when not in use.
Risk of fire and electric shock. Remove
power adapter from the receptacle when not in
use.
Disconnect power adapter before servicing.
Do not ground the secondary circuit to the
enclosure of this power adapter.
Risk of electric shock. Connect only to
properly grounded outlets.
Do not incinerate.
To avoid electric shock, do not touch
exposed live terminals or connected parts
as electric shock hazards exist in this output
circuit.
To reduce risk of damage to electric plug
and cord, pull by plug when disconnecting
power adapter.
Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress.
Do not operate power adapter with damaged
cord or plug. Replace them immediately.
Do not operate power adapter if it has
received a sharp blow, been dropped, or
otherwise damaged in any way. Take it to a
qualified service center.
Do not disassemble power adapter; take it
to a qualified service center when service or
repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
To reduce risk of electric shock, unplug
power adapter from receptacle before
attempting any maintenance, cleaning, or
storage.
NEVER insert any objects into the power
adapter's air vents. Electric shock or damage
to the power adapter may result.
Never short the adapter terminals.
Do not use the product if the tool or adapter
terminals (adapter mount) are deformed or
damaged. Deformed terminals could cause
short circuit that will result in fire.
Keep the tool's terminals (adapter mount)
clean. Periodically examine the terminals
(on the tool and adapter) prior, during, and
after operation. Never short the terminals.
Shorting terminals will result in fire.
The product is intended for use in Pollution
Degree 2 or PD2 environments. Operate
only in areas of non-conductive pollution. A
temporary conductivity caused by condensation
is normally expected.
This adapter is designed for use only
with select FLEX power tools including
FLEX Miter Saw FX7141A and Table Saws
FX7211, FX7221. It is necessary to confirm
compatibility by consulting the instruction
manual or the markings of the particular
power tool. Failure to confirm compatibility
before the use of the adapter with specific
power tools could result in fire hazard.
SAVE THESE INSTRUCTIONS - TO
REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, CAREFULLY FOLLOW THESE
INSTRUCTIONS.
-4-
Publicidad
