Triton Blue TR-DMX48-2 Manual De Usuario página 20

3) If you are not satisfied with the scene or scenes, you may tap the Rec. Clear button while pressing and
holding the Record button, all LEDs will flash, indicating the scenes have been cleared
2.5 Delete a Step or Steps
1) Record enable
2) Tap the Step button to scroll to the step you wish to delete
3) Tap the Delete button when you reach to the step you wish to delete, all LED will flash briefly indicating the
deletion of the step
4) Continue steps 2 and 3 until all the unwanted steps have been deleted
5) Tap the Rec. Exit button while pressing and holding down the Record button, the Scene LED goes out,
indicating the exit of Edit mode
EXAMPLE: Delete the 3rd step of the program on Flash button 25 on Page 2
1) Record enable
2) Tap the Mode Select button to select CHASE
3) Tap the Page button until Page 2 LED lights
4) Tap the Flash button 25 while pressing and down the Edit button, the Scene LED lights
5) Tap the Step button to scroll to the third step
6) Tap the Delete button to delete the step
7) Tap the Rec. Exit button while pressing and holding down the Record button to exit Edit mode
2.6 Delete a Step or Steps
1) Record a scene or scenes you wish to insert
2) Be sure you're in and CHASE
3) Tap the Step button to scroll to the step which you wish to insert before. You may read the step from the
Segment Display
4) Tap the Insert button to insert the step you've created, all LEDs will flash, indicating the step is inserted
5) Exit Edit mode
EXAMPLE: Insert a step with channels 1-12 fully on at a time between step 4 and 5 of program 35
1) Record enable.
2) Push Channel sliders 1-12 to the top and record the scene as a step.
3) Tap the Mode Select button to select CHNS SCENE mode.
4) Tap the Page button until Page 2 LED lights.
5) Tap the Flash button 35 while holding down the Edit button, the corresponding scene LED lights.
6) Tap the Step button to scroll to the step 4.
7) Tap the Insert button to insert the scene you've created before.
2.7 Delete a Step or Steps
1) Enter Edit mode
2) Tap the Step button to scroll to the step you wish to modify
3) Press and hold the Up button if you want to raise the intensity. If you want to lower the intensity, press and
hold down the Down button
4) While holding down the Up or Down button, tap the Flash button corresponding to the DMX channel of the
scene you wish to modify until you reach the desired intensity value read from the Segment Display. Then you
may tap the Flash buttons until you are satisfied with the new scene
5) Repeat steps 2, 3 and 4 until all the steps have been modified
6) Exit Edit mode
20.
SCENE mode
SCENE Enter the Edit mode
User Manual | TR-DMX48-2 by Triton Blue | June 2023 | www.triton-blue.com