Triton Blue TR-DMX48-2 Manual De Usuario página 21

3.- RUNNING
3.1 Running Chase Programs
1) Tap the Mode Select button to select CHNS SCENES mode indicated by the red LED.
2) Tap the Page button to select the correct page the program you wish to run is located.
3) Push Master Slider B to its maximum position(fully down).
4) Move the desired Channel slider (25-48) to its maximum position to trigger the program, and the program
will fade in depending upon current fade
3) While holding the Record and Edit buttons, tap the desired Flash button to enter a new Record Code
The Record Code consists of 4 Flash buttons(the same button or different buttons), be sure your new Record
Code consists of 4 Flash buttons time.
5) Move the Channel slider to adjust the output of the current program
3.2 Running a Program To Audio
1) Use built-in microphone or plug the audio source into the RCA Audio jack
2) Select your program as described above
3) Tap the Audio button until its LED lights, indicating Audio mode is active
4) Use the Audio level slider to adjust the music sensitivity
5) To return to normal mode, tap the Audio button a second time causing its LED goes out, the Audio mode is
disengaged
3.3 Running a Programs With the Speed Slider
1) Be sure the Audio mode is disengaged, that is the Audio LED goes out
2) Select your program as described above
3) Move the Speed slider to the SHOW MODE position (the button), then tap the Flash button (25-48) while
pressing and holding down the Rec. Speed button, the corresponding program will not run with the Standard
beat any longer
4) Now you may move the Speed Slider to select your desired speed
NOTE: The step 3 is not necessary if the selected program is not recorded with Standard Beat
3.4 Running a Programs With the Standard Beat
1) Be sure the Audio mode is disengaged. Tap the Mode Select button to select CHASE SCENE mode
2) Tap the Park button to select Mix Chase mode, the LED lights indicating this selection
3) Select your program as described above
4) Move the Speed slider until Segment Display reads your desired value. You may tap the Tap Sync button
twice to define your beat time
5) While pressing and holding down the Rec. Speed button, tap the Flash button(25-48) that stores the
program
6) The program will then run with the set time or beat when engaged
7) Repeat steps 4 and 5 to set a new beat time
3.4 Chang the Speed Mode between 5 Minutes and 10 Minutes
1) Press and hold the Record button
2) Tap the Flash button 5 or 10 three times while holding down the Record button
3) The 5 MIN or 10 MIN should light up indicating the Speed slider is set to run in the 5 or 10 minute mode
User Manual | TR-DMX48-2 by Triton Blue | For Professinal use only, not for residential use
21.