Publicidad
Idiomas disponibles
Idiomas disponibles
I _ILWARNING
I
Disconnect
the router
from the
power supply before installing
router into the table,
making adjustments,
changing
accessories,
removing
the router from the table,
performing
maintenance,
or storing the tool. Such
precautionary
safety measures
reduce the risk of
unintentional
tool operation.
TABLETOP
INSERT
RINGS
(FIG. 19)
This router table includes
three insert rings with the
following
hole sizes:
(8) 1 in. in diameter, for use with bits with diameters
up to 7/8 in.
(9) 2 in. in diameter, for use with bits with diameters
up to 1% in.
(10) 2% in. in diameter, for use with bits with diameters
up to 2% in.
No insert ring is used for bits with diameters
over 2% in.
and up to 3% in.
I A WARNING
I
Do not use the router table with
I
ALL
I bits over 31/2 in. in diameter.
Bits
larger than 31/2 in. exceed
the clearance
hole in the
tabletop
insert rings. Bits larger than 31/2 in. can contact
insert plate or insert ring, throwing
fragments.
I A WARNING
I Do not
alter tabletop
insert ring
I
All
I or insert plate bit hole. Match the
cutting
diameter
of the bit to the inner diameter
of
the insert ring or insert plate
bit hole such that the
difference
is no less than 1/16 in. on a side. Insert
rings are meant to reduce the gap between
the cutting
diameter
of the bit and table so that workpieces
maintain
full support
of the table while routing.
Fig. 19
TO INSTALL
TABLETOP
INSERT
RINGS
(FIG. 19):
1. Select the insert ring (8-10) that best accommodates
the router bit to be used.
2. Press the insert ring (8-10) into the large hole in the
router mounting
plate (7). If the fence is in the way,
loosen the clamping
knobs on the fence and slide
the fence back out of the way.
3. Press down evenly over the tabs until the insert ring
(8-10) locks into place.
4. To remove, pull up gently until the tabs disengage.
When not in use, store insert rings (8-10) behind
the storage panel (4) in the table leg or in another
convenient
place.
._WARNING
Do not use, attempt
to change,
or
I
I remove
tabletop
insert rings from
the tabletop
unless the router
is off and unplugged.
Such precautionary
safety measures
reduce the risk of
unintentional
tool operation.
21
Publicidad
