Publicidad
Idiomas disponibles
Idiomas disponibles
[ kWARNING I
Before
proceeding
any further,
make
sure the switch
on the router
is in the OFF position
and the switch
lever is in the
OFF position.
[. kWARNINGI
Never
leave the router unattended
while
it is running
or before
it
comes
to a complete
stop.
[__WARNING
I
Before
starting
to work, ensure
that
the power
cords
from the router,
accessories,
the switch
case, and the extension
cord
do not and cannot
come
in contact
with the router
or any moving
parts
of the router.
Such precautionary
safety measures
reduce the risk of injury due to loss
of control.
The switch
power
cord can now be plugged
into the
extension
cord.
ROUTER
AND SWITCH
OPERATION
This section
explains
operation
of the switch
with the
power cord plugged
into the extension
cord.
The router
will turn ON when the red paddle
on the
switch
box is pulled
up to the ON position.
1. Position
the ON/OFF switch
on the router in the
ON position.
On certain routers this will require the
use of the switch trigger and "LOCK-ON"
button.
(Consult router owner's
manual.) Make sure the
switch
on the switch
case is in the OFF position
when doing
this.
2. To turn the router ON, pull up the red paddle to the
ON position.
See page 23.
3. To turn the router OFF, press the red paddle to the
OFF position.
See page 23.
CIRCUIT
BREAKER
NOTE: in the event of an overload,
the internal switch
circuit breaker will trip the switch to the OFF position.
This will interrupt
power to the router and any accessory
plugged
into the switch
itself. If this occurs,
proceed
as follows:
1. Push the red plastic paddle to the OFF position
and
unplug the switch cord from the wall outlet or exten-
sion cord.
2. Turn router switch to OFF position.
3. Remove the workpiece
from the router table.
4. Correct the cause of the overload situation.
For
example,
if too many accessories
are plugged
into
the switch,
or combined
amperage
exceeds the
switch rating, remove the accessory.
Other causes
include the removal of too much stock or use of too
high a feed rate.
5. Press the circuit reset button on the bottom
of the
switch box.
6. Plug the switch
power cord into the wall outlet or
extension
cord.
7. Restart the router as described
in the section
ROUTER AND SWITCH
OPERATION
on this page.
I^WARNING
Ill
the switch
case does
not work
In
J
and you have tried
to RESET the
circuit
reset button
as described
above:
* Unplug
ALL electrical
connections.
* Remove
the switch
from the router
table
and obtain
a replacement
switch
by calling
1-800-624-0488.
WHEN THE ROUTER TABLE
IS NOT IN USE
1. Make sure the switch
is in the OFF position.
2. Remove the lockout
key (6A). See page 23.
3. Store the lockout
key in a safe location
where
it is
not available
to children
and other unauthorized
persons.
4. Unplug the switch power cord from the wall outlet or
extension
cord.
5. Remove the router bit from the router.
6. Position
the router collet assembly
below the top of
the router table.
NOTE: If the key should
become
lost or damaged,
replacement
keys are available
from your
local Sears
store or at www.craftsman.com.
24
Publicidad
