Publicidad
Idiomas disponibles
Idiomas disponibles
Turn thepower s witch "OFF" a ndunplug thepower
cordfromitspower s ource priortoanymaintenance,,
LUBRICATION
The Bench Grinder has sealed lubricated bearings in
the motor housing that do not require any additional
lubrication from the operator,,
CLEANING
With the Bench Grinder unplugged,
rotate the abrasive
wheels slowly and inspect for any damage
or trapped
shavings,,
CAUTION: REPLACE the abrasive wheels if there is
amy damage at all FAILURE to reptace a damaged
wheel can cause serious injury to the operator,
CAUTION: DO NOT USE FLAMMABLE MATERIALS
to clean the Bench Grinder, A ctean dry rag or brush is
all that is needed to remove dust and debris buildup,,
Repairs to the Bench Grinder should be performed by
trained personnel only Contact your nearest Sears
Canada Inc, outlet for authorized service° Unauthorized
repairs or replacement with non-factorj
parts could
cause serious injury to the operator and damage to the
Bench Gfinde[,
TO PREVENT INJURY TO YOURSELF or damage to the Bench Grinder, turn the switch to the "OFF" position and
unplug the power cord from the electrical receptacle before making any adjustments°
PROBLEM
LIKELY CAUSE(S)
SOLUTION
Motor does
1o Machine not plugged in
1,, Plug power cord into electrical receptacle
not run
2,, Power switch in "OFF" position
2 Lift switch to "ON" position
3. Power cord is faulty
3_ Return to Sears Service Center
4., Fuse or circuit breaker are open
4. Overloaded electrical circuit
5. Damaged motor
5. Return to Sears Service Center
,,
,,,,,,,,, .....
Motor does not
have full power
Motor stalls or
runs slow
Fuse blows or
circuit breaker
trips
1., Incorrect line voltage
2. Damaged motor
I., Motor is overloaded
2. Poor air circulation around motor
1., Motor is overloaded
2oIncorrect line voltage
3. Capacitor has failed
t., Motor overloaded
2,, Overloaded electdcal circuit
3. Wrong fuse or circuit breaker
4. Undersized or excessive length of
extension cord, see manual
5,, Grinding wheels are blocked
1o Have a qualified electrician check line for proper voltag
2_ Retum to Sears Service Center
I. Reduce pressure on workpiece
2_ Remove any blockage around motor
1., Reduce pressure on workpiece
2o Have a qualified electrician check line for proper volta_
3o Retum to Sears Service Center
1o Reduce pressure on workpiece
2_,Reduce the amount of items on circuit
3o Replace with correct fuse or circuit breaker
4,, Use correct size
5,, Unplug machine and remove obstruction
12
Publicidad
