Publicidad
Idiomas disponibles
Idiomas disponibles
H Hand guard (for attaching under the additional
side-mounted handle.)
I Extension piece (for working with supporting
discs. Increases the distance between the
spindle and the supporting disc by approx. 35
mm)
J Supporting disc for fibre discs (always attach
using the supporting disc clamping nut
supplied.) (always use with the hand guard
attached.)
K Fibre discs (always use with the hand guard
attached.)
L Steel wire brushes (always use with the hand
guard attached.)
M Bench cut-off stand
N Adjusting nut (8)
For complete range of accessories, see
www.metabo.com or refer to the main catalogue.
11. Repairs
Repairs to electrical tools must be carried out
by qualified electricians ONLY!
If the mains connection cable of this tool is
damaged, in order to prevent endangering
personnel and property it must be replaced by the
manufacturer, or the Customer Service of the
manufacturer, or a similarly qualified person.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of with the
household waste, but at a special collection point
for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanation of details on page 3. Subject to
changes serving technical progress.
Ø
= max. diameter of accessory
t
= max. permitted thickness of clamping
max,1
shank on accessory when using clamping
nut (8)
t
= Roughing disc/Parting disc:
max,3
max. permitted thickness of accessory
M
= Spindle thread
l
= Length of the grinding spindle
n
= No-load speed (maximum speed)
I
= Current at 120 V
120 V
m
= Weight without mains cable
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a
= Vibration emission value (sanding
h, SG
surfaces)
a
= Vibration emission value (sanding with
h, DS
sanding pad)
K
= Uncertainty (vibration)
h,SG/DS
Typical A-effective perceived sound levels:
L
= Sound pressure level
pA
L
= Acoustic power level
WA
K
, K
= Uncertainty
pA
WA
Wear ear protectors!
ENGLISH en
11
Publicidad
