Publicidad
Idiomas disponibles
Idiomas disponibles
Installation recommendations
Remember there are specific standards that have to be strictly followed regarding the safety rules
of electrical installations and automatic gates and doors.
As for the legal requirements and standards that must be adhered to, please take notice of the
following points to ensure maximum safety and reliability of your installation.
1) Before installing, check the surrounding environment. Carefully evaluate any hazards which
could be physical damage (transiting vehicles, parts of trees falling etc.), possible contact with
persons' bodies (insects, leaves, etc.), flooding hazards, or any other exceptional events.
2) Check the main voltage numbers is the same as the numbers that are given on the rating
plate and in this manual.
3) Check and make sure if there is suitable electrical protection against short circuits/power
spikes and proper earthed on the main supply.
Remember the unit having main voltage running through it (electrocution hazard, fire hazard).
4) Take care with the control unit; the parts may be subject to damage if the control unit is
abused.
5) Make sure that you have all the necessary materials, and they are suitable for this kind of use.
6) Read all the instructions thoroughly, and make sure they are understood before attempting to
install the opener.
7) Before starting the installation carefully analyze all the risks relating to automating the door.
Verify that the door is automated in a sound condition and that the mechanisms are in good
working order. Observe the safety margins and minimum distances.
8) Carefully evaluate the safety devices to be installed and the right place to install them; always
install an emergency stop device for power interruption to the opener if it is required.
9) Once the risks have been analyzed, install the opener and relative safety devices, emergency
stop and/or photoelectric cells.
Important note: As for additional safety rules, we strongly recommends the fitting of Photo
Electric safety beams on all installations.
10) While installing the opener, strictly follow all the instructions given in the instruction manual. If
some points or procedures in this manual are not very clear, do not install the unit until all
doubts have been cleared up with our technical department.
4. Limit setting
ENGLISH
FIG.11
17
Publicidad
