Publicidad
Idiomas disponibles
Idiomas disponibles
Fitting rotor segment No. 12
No. 1
No. 11
Step 1
22
Installation instructions
No. 1
No. 12
No. 11
Fitting the last segment No. 12 is essentially identical to the
assembly of previous rotor segments - steps 1 and 2.
- Remove 2 bolts M8x25 (item 10)
12
- Remove 2 fitting bolts M8x30 (item 11) incl. nuts and
washers (item 12) from segment No. 1.
11
10
Place the last segment No. 12 onto the lifting equipment.
Lift it to the installation height and slide it onto rotor segment
No. 11.
Place the segment onto the lifting equipment so
Please
the strut with the centre notch is facing down-
note
wards. This allows the centre bolt of segment No.
11 to slot into the notch.
- Slide the segment into its end position – repeat step 1.
If it is not possible to insert all bolts M8 (items 10 and
Please
11), first fit the tensioning strap to the outside rim and
note
turn the rotor until the segment is at 12 o'clock. The
weight of the rotor should cause the gap to widen, so
that the segment moves closer to the hub, allowing the
bolts to be inserted.
- Fit the casing and tensioning strap - repeat step 2 (p.7)
- Tighten the rotor casing by hand.
3065280_201804
Publicidad
