Joie i-Gemm 2 Manual De Instrucciones página 6

3. Line up the ISOFIX connectors with
the ISOFIX guides, and then
click both ISOFIX connectors into
the ISOFIX anchor points.
!
Make sure that both ISOFIX
connectors are securely
attached to their ISOFIX anchor
points. There should be two
audible clicks and the colors of
the indicators on the both
ISOFIX connectors should be
-1
completely green.
5
!
Check to make sure the base is
securely installed by pulling on
the both ISOFIX connectors.
6
4. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
6
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
9
5
5
1
3
1
2
6
5. The completely assembled base is
shown as
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points.
!
The load leg must be installed
correctly with green indicator.
-2
7
6. Push the infant carrier module
down into the base
child restraint is secure, the shell
indicator shows green.
!
Pull up on the infant carrier
module to be sure it is securely
latched into the base.
-3
7
-1
7
, if the infant
8
9
7
2
1
8
9
10