Publicidad
Idiomas disponibles
Idiomas disponibles
with your product. Accessories that may be suitable for one product may
create a risk of injury when used with another product.
• Warning: ALWAYS unplug the light before cleaning. Remove dirt and
grime as soon as it accumulates. Use a soft, damp cloth and a mild
soap, if needed.
• Charge the light which has battery every 3 months if not in constant
using, and after each use, if it is used often to ensure longevity.
• Replace the battery with manufacture and battery designation only.
OPERATING INSTRUCTIONS
For AL20RSW, AL60RSW:
• Before using the first time, plug the charger into any 100~240V AC
standard power source to let unit fully charge until the battery volume
bar at the back of the light reach to 100%.
• Press the
button to turn on or turn off the light.
• Press the
or
button to adjust the brightness.
• Press the button
to activate the power bank function, the power bank
indicator light will turn on, then use an USB cable to connect the mobile
device you want to charge. Press the button
bank function, and the indicator will light off.
• Press
or
to activate battery capacity indicator.
• The light will flash as a low power warning prior to the battery
running out.
For AL60CSW, AL100CSW:
• Before using, plug the unit into any 100~240V AC standard power source.
The
indicator will light when connect successfully.
• Press the button
to turn on or turn off the light.
• Press button
or
to adjust the brightness.
• Power bank function: use a USB cable to connect the digital device you
want to charge.
• Power bank output: 5V 1A
1-855-SWTOOLS — www.southwiretools.com
again to turn off power
BLUETOOTH CONTROL FOR BRIGHTNESS
FOR AL60RSW, AL60CSW and AL100CSW
• From either the
or
GET IT ON
your smart phone or tablet.
• Step 1: Press the button
on the lamp to turn on the light.
• Step 2: Turn on Bluetooth on your smartphone or tablet.
• Step 3: Open Southwire application and select "LAMPS" tab.
• Any available Southwire Bluetooth light will appear on the screen.
• Choose the lights you want to control, up to 4 lights.
• Press
to change the name of the light (optional).
• One light can be controlled by one device at the same time.
• Step 4: Select the "ON" tab to turn on the light. If using AL60RSW,
this function will only be available when the 120V power supply is
powering / charging the light
• Step 5: Select
tab and slide vertically on the screen to adjust the
brightness of the lamp.
• Step 6: Select "OFF" tab to turn off the light.
THE BLUETOOTH
WORD MARK AND LOGOS ARE REGISTERED TRADEMARKS
®
OWNED BY BLUETOOTH SIG, INC. AND ANY USE OF SUCH MARKS BY
SOUTHWIRE IS UNDER LICENSE.
COMPLIANCE
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
, download the Southwire application to
1-855-SWTOOLS — www.southwiretools.com
Publicidad
