BabyOno SHELLY Manual Del Usuario página 3

CONTROL PANEL INSTRUCTIONS
PRODUCT PARAMETER INFORMATION
Model
Input Power
Suction Strength
Charging Time
Rated Power
Output Power
Battery Capacity
Running Time
MODE
Expression
Two-in-one
Dual-frequency
ASSEMBLY INSTRUCTIONS
01
02
03
501
100-240V, 50/60Hz
=<0.038MPa
—150 mins
5W
5V/1A
1100 mAh
—120 mins
LEVEL RANGE
1-7
1-7
1-7
01. Insert the duckbill valve into the interface of the
bowl and install the breast shield to the bowl. Please
note that it is installed place when the milk outlet of
the bowl fits the protrusion of the breast shield.
02. Choose 28 mm breast shield or 24 mm or 21 mm
insert, depending on your needs.
03. Install the pump unit-silicone gas storage-storage
bowl as shown in the above picture.
OPERATING INSTRUCTIONS
Maintain proper posture and relax. Place the breast
shield on your breast with the nipple in the centre.
Press and hold on top of main pump unit to turn on
the power. The digital display screen will turn on and
the 1 minute timer will start once the main pump unit
is being turned on. If the main pump unit is idle for 1
minute, it will turn off automatically.
Press to select desired mode.
Select to enter EXPRESSION MODE. Touch + to
increase suction strength, - to reduce suction strength.
Suction strength can be set between L1 and L7. Each
setting offers a different pumping strength, from weak
to strong.
Select to enter TWO-IN-ONE MODE. The breast pump
will provide a pumping cycle of massaging eight (8)
times and pumping once (1). This is a good way to
relieve pain in full breasts and to produce plenty of
breast milk in little time. Touch + to increase suction
strength, - to reduce suction strength. Suction strength
can be set between L1 and L7. Each setting offers a
gentle massage and different pumping strength, from
weak to strong.
Select to enter DUAL-FREQUENCY MODE. This is a
creative new pumping experience on both high and
low suction strength settings. The pumping circle
of weak4stop4strong is an effective way to correct
inverted nipples. Touch + to increase suction strength,
- to reduce suction strength. Suction strength can be
set between L1 and L7.
Sleep Mode: The default operating cycle of the main
pump unit is 30 minutes. After 30 minutes, the pump
3