Bosch UniversalAquatak 36V-100 Manual Original página 15

Battery status indicator
The battery is equipped with a status indicator, which indic-
ates its charge condition. The status indicator consists of 3
green LEDs.
Press the status indicator button (16) in order to activate
the status indicator. After approx. 5 seconds, the status in-
dicator goes out automatically.
The charge condition can also be checked when the battery
is removed.
LED Indication
Continuous lighting of 3
green LEDs
Continuous lighting of 2
green LEDs
Continuous lighting of 1
green LED
Flashing of 1 green LED
When no LED lights up after pressing the button, then the
battery is defective and must be replaced.
For safety reasons, the charge condition of the battery can
only be checked when the garden product is at a standstill.
During the charging procedure, the three green LEDs light up
one after the other and briefly go out. The battery is fully
charged when the three green LEDs light up continuously.
The three green LEDs go out again approx. 5 minutes after
the battery has been fully charged.
Operation
To prevent damage to the appliance, do not allow it to op-
u
erate dry.
Starting
Mount the filter (3) onto the water connection on the ma-
chine.
Connect the water hose (not supplied) to your mains water
supply and connect the hose to the filter (3) on the machine
or follow the instructions in the section "Use with alternative
water sources" to connect a self-priming accessories. (see
figure G)
Connect the water hose to the hose connection on the ma-
chine (10) and the hose connection of the gun (18).
Open the water tap.
Deactivate the trigger safety lock (14) to release the trigger
(13). Fully press the spray-gun trigger (13) until the water
flows evenly and the air is cleared from the machine and the
high-pressure hose. Release the spray-gun trigger (13). Ac-
tivate the trigger safety lock (14).
Attach the lance (12) and the nozzle (1) to the spray gun
(4). (see figure E)
Select the desired spray jet by turning the nozzle (1). (see
figure K)
Press the on/off button (8).
To use ECO mode, press the ECO mode button (9).
Bosch Power Tools
Battery Capacity
≥ 2/3
≥ 1/3
≤ 1/3
Reserve
Direct the lance (12) downwards.
Deactivate the trigger safety lock (14) to release the trigger
(13). (see figures H and I)
Fully press the spray-gun trigger (13).
Autostop Function
The machine is designed to switch off the motor as soon as
the spray-gun trigger (13) is released.
Auto-off Function
The motor switches off when the product runs continuously
for 30 minutes.
Autosleep Function
The machine automatically switches off after 15 minutes
without operation.
Working Advice
Working advice for cleaning with detergents
Only use cleaning agents suitable specifically for high
u
pressure washers.
Detergents must not be used undiluted. The products are
u
safe to use as they contain no acids, alkalis or substances
which are detrimental to the environment. We recom-
mend that the detergents are kept out of the reach of chil-
dren. If detergent comes into contact with the eyes, wash
immediately with plenty of water and if swallowed contact
a doctor immediately.
Comply with the application, disposal and warning in-
u
structions of the detergent manufacturers.
We recommend using cleaning agent sparingly in the interest
of environmental protection. Observe the recommended di-
lution on the detergent label.
Recommended cleaning method
Step 1: Attach the trio nozzle and remove the heavy dirt.
Step 2: Attach the foam bottle and spray on the detergent
sparingly.
Step 3: Rinse off the loosened dirt and detergent using the
trio nozzle.
Note: When cleaning a vertical surface spray off dirt/deter-
gent from the bottom and work in an upwards direction.
Rinse from the top and work downwards.
Use with alternative water sources
This high-pressure washer will self prime and can draw water
from water tanks and natural water sources. It is IMPORTANT
that the water is clean and the BOSCH inlet filter is clear and
fitted to the machine.
Open tanks/containers and natural water
sources
Use the self-priming accessory kit comprising:
– Inlet strainer with non return valve
English | 15
F 016 L94 142 | (27.07.2023)