Publicidad
Idiomas disponibles
Idiomas disponibles
16 | English
– 3 m reinforced supply hose
– Universal coupling to the pressure washer
This enables the pressure washer to draw water up to 0.5 m
above the water level in the source. This can take up to ap-
prox. 60 seconds.
Submerge the 3 m hose in water to displace the air. Connect
the 3 m supply hose to the pressure washer ensuring that
the inlet strainer remains submerged in the water source.
Turn on the machine and activate the trigger with the Lance
disconnected. If water does not come out after 60 seconds,
switch off and check all connections. If water comes out,
switch off the pressure washer and connect the spray gun
and spray lance for operation.
It is important to ensure that all hose and coupling connec-
tions are of good quality, air tight and that all washers are in
good condition and correctly seated in place. Failure to do
so may affect the self priming performance.
Water Tanks with outlet connections
When connecting the pressure washer to a water tank with a
suitable tap outlet, first connect the supply hose (not
provided) to the tank outlet, open the tap to allow the water
to displace all the air in the hose and then connect to the
pressure washer.
Troubleshooting
Problem
Possible Cause
Motor refuses to start
Battery discharged
Battery too hot/cold
Machine frozen
Battery not inserted correctly
Battery compartment not properly closed
Machine switches off
The automatic sleep function has been activated Press On/Off switch for activation
Battery discharged
Battery too hot/cold
Water leaks from ma-
Leaking pump
chine
Leaking connections
Motor starts in standby
Pump, spray gun or hose leaking
mode
Hose cannot be re-
When machine is still switched on, pressure in
moved
system increases the required force to remove
connectors
Motor starts, but no
Nozzle partly blocked
pressure present
Insufficient water supply
Nozzle worn or damaged
Motor "sounds" but no
Problems with TSS (Total Stop System) device
function
F 016 L94 142 | (27.07.2023)
Product LED indicator
X5
X5
Corrective Measure
Recharge battery
Allow the battery to warm up/cool down
Wait until machine has defrosted
Remove the battery and reinsert it correctly
Close the battery compartment
Recharge battery
Allow the battery to warm up/cool down
Slight water leaks are possible; in case of excess-
ive leaks, contact Bosch Service Centre
Check if connections are properly mounted
In case of continuous malfunctions in standby
mode, contact Bosch Service Centre
Switch machine off, then pull trigger to release
the pressure
Clean nozzle
Check the water filter. Change to alternative wa-
ter supply.
Replace the nozzle
Contact your Bosch Service Centre
Battery low
LED of the on/off button
flashes green
Battery fully discharged
And/or
Non-compatable battery
used
Both LEDs flash green 5x
Battery too hot
LED of the on/off button
lights up red
Product error
LED of the on/off button
flashes 5x red
Bosch Power Tools
Publicidad
