Black and Decker Smartselect BDPH200B Manual De Instrucciones página 26

26 • ENGLISH
TROUBLE! MATERIAL RUNS OR DRIPS.
WHAT'S WRONG?
Spraying too much material.
Spraying too slowly.
Spraying too close.
Viscosity too thin.
TROUBLE! TOO MUCH OVER SPRAY.
WHAT'S WRONG?
Sprayer too far from surface.
Too much material being sprayed.
TROUBLE! LITTLE OR NO MATERIAL BEING RELEASED.
WHAT'S WRONG?
Check valve ball stuck.
Spray nozzle/tip clogged.
Pickup tube loose or clogged.
Material adjustment knob setting too low.
Air inlet blocked.
Material too thick.
TROUBLE! MATERIAL BEING SPRAYED IS SPLATTERING.
WHAT'S WRONG?
Viscosity of material is too high.
TROUBLE! SPRAYER PULSATES.
WHAT'S WRONG?
Air filter clogged.
Material in canister almost empty.
TROUBLE! LIQUID COMES OUT SIDE OF CANISTER.
WHAT'S WRONG?
Lid not on square or tight enough.
Paint on threads of canister and lid.
TROUBLESHOOTING
WHAT TO DO...
Reduce air flow by turning material adjustment knob.
Increase speed of application.
Increase distance from surface.
Check dilution recommendation.
WHAT TO DO...
Reduce distance to surface.
Reduce air flow by turning material adjustment knob.
WHAT TO DO...
Remove check valve. Depress ball to loosen. Add lubricant Figure Q.
Clean nozzles.
Check tube.
Increase setting
Clean or change air filter.
Check viscosity recommendation
WHAT TO DO...
Thin material per manufacturer recommendation.
WHAT TO DO...
Clean or change filter.
Refill canister.
WHAT TO DO...
Remove lid and reattach squarely and evenly, then tighten lid securely.
Clean threads on top and sides of canister and lid.