TROUBLESHOOTING
(CT-FX729M only)
Errorcodes
In the following cases the corresponding
error
code indication appears. Follow the suggestions
below to solve the problem,
If the error code
indication does not disappear, consult an AIWA
service center.
ERRORO1
ERROR02
ERROR03
ERROR04
ERROR05
The disc magazine is not properly
inserted inthe CD changer. Reinserl
the
magazine.
Refer
to the
instruction
manual
for the CD
changer.
No discs are loaded in the disc
magazine.
Insert discs properly.
Refer to the instruction manual for
the CD changer.
Focus error. Check that the discs
are loaded
properly
in the disc
magazine (right side up, etc.).
Problem with the CD changer, Reset
the unit by pressing the reset button.
If this does not solve the problem,
consult an AIWA service center.
The CD changer
is overheated.
Allow the cha;ger
to cool off by
moving the vehicle
out of direct
sunlight,
Resetbutton
The Reset button is visible when you detach the
front panel. Tty pressing this button if a connected
CD changer does not operate properly, To press
this button, use the tip of a pointed object such as
a pencil or toothpick.
Note that all your setting stored in memory,
however, will be erased by pressing this button.
MAINTENANCE
Cleaning the front panel
When the front panel is soiled, wipe the surface
of the panel with a soft, dry cloth,
Cleaning the tape head
Use a
cleaning cassette
to clean the playback
head and capstans approximately once a month,
If the playback head is dirty, the high tones may
not be reproduced properly.
Cleaning the connector
The connector on the reverse side of the front
panel needs to be cleaned occasionally.
Wipe
the surface of the connector with a cotton swab
slightly moistened with alcohol.
Reset button
MGL/5H16