Sedus se:motion Instrucciones De Uso página 6

English
Function
A Height of the seat
Lowering the seat:
®
lever upwards (the seat will drop slowly)
the lever at the desired height will lock the position
Raising the seat: Stand up
®
1.
(the seat will rise slowly)
desired height will lock the position
B Backrest tilt
Locking the backrest: remove the load on the back-
®
rest, push the slider to the right = backrest is locked
Releasing the lock: remove the load on the backrest,
®
push the slider to the left = backrest is dynamically
adjusted
C Adjusting the multifunction armrests
To adjust the height of the armrests:
®
the button Raise or lower the armrest to the desired
2.
height Release the button to lock the armrest
3.
Depth: slide the armrest cover backwards or forwards
®
Width: slide the armrest cover inwards or outwards
®
Swivel contact surfaces in any position: up to 25°
®
inwards, up to 13° outwards
D Lumbar support can always be added later
Attach lumbar: Position lumbar support at the
®
1.
desired height Ensure it is centrally mounted
2.
Push the four fixing clips on the lumber pad into
3.
the larger holes of the hole pattern on the backrest.
E Height of the footring (counter underframe)
Adjusting the footring:
®
anticlockwise – the footring loosens
footring to the desired position
screw clockwise
Sit down on the seat
1.
Releasing
3.
Pull the lever upwards
2.
Releasing the lever at the
3.
Press and hold
1.
Turn the knurled screw
1.
Move the
2.
Tighten the knurled
3.
Tips for users
Correct use
Pull the se:motion may only be used for the purpose intended
2.
while exercising due care and attention.
Using it inappropriately (e.g. as a stepladder, sitting on
the edges of the seat shell or placing extreme weight
on one side) could result in accidents.
The maximum user weight is indicated on the product
label which is attached to the product.
Castors
Before using the product for the first time, please
remove the coloured transport protection.
A variety of castors are available, for the sake of
your safety and for use on different types of flooring
in accordance with safety regulations:
– hard castors for soft flooring,
– soft castors for hard flooring.
Changing castors: this might be necessary, for instance,
after moving office, or after the instal lation of a new
floor covering – simply pull out the castors and push
new ones in.
To protect the floor covering and increase the service
life of the castors and glides, it is recommended or
necessary to regularly check, clean and, if required,
replace them. Should you have any questions, please
do not hesitate to contact our Customer Service.
Plastic parts
Soapy water is suitable for cleaning. Please do not use
any aggressive cleaning materials.
Seat height adjustment
We recommend cleaning the piston rod regularly with
a cloth. Other work on the gas spring, e.g. replacement,
may only be carried out by trained staff.