Descargar Imprimir esta página

Craftsman 917.377152 Manual Del Propietário página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

_CAUTION:
Before performing
any
service
or adjustments:
1. Release
control bar and stop engine.
2.
Make sure the blade and all moving
parts have completely
stopped.
3.
Disconnect
spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST
cu'n'ING
HEIGHT
See '1"O ADJUST
CUI-I-ING
HEIGHT"
in
the Operation
section
of this manual.
REAR
DEFLECTOR
The rear deflector, attached between
the
rear wheels of your mower, is provided to
minimize the possibility that objects will
be thrown out of the rear of the mower
into the operator mowing position. If the
deflector becomes
damaged,
it should be
replaced.
TO REMOVE/REPLACE
DRIVE
BELT
1. Remove
drive cover.
Remove
belt
from gearcase
pulley by pushing
down on pulley and rolling belt off it.
2. Turn lawn mower on its side with air
filter and carburetor
up.
3.
Remove
blade.
4.
Remove
debris shield.
5.
Remove
belt from engine pulley on
crankshaft.
6.
Install new belt by reversing above
steps.
7.
Always
use factory
approved
belt to
assure fit and long life.
Drive
cover
Belt
Push
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all parts
attached to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3.
Squeeze
lower handle
in to remove
it
from mounting
pins.
4. Turn lower handle
over to raise or
lower
handle.
5.
Squeeze
lower handle
in and position
holes onto mounting
pins on handle
bracket.
6.
Reassemble
upper
handle
and all
parts removed
from lower handle.
Lower
handle
ROTATE
Mowing
position
Hairpin
Mounting -
pin
LOW POSITION
TO ASSEMBLE
GRASS
CATCHER
1. Put grass catcher frame into grass bag
with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.
2. Slip vinyl bindings
over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them in warm water for a few minutes.
If
bag gets wet, let it dry before
using.
_I, CAUTION:
Do not run your lawn mower
without
clipping
deflector
or approved
grass catcher
in place. Never attempt
to
operate
the lawn mower with the rear
14door
removed
or propped
open.

Publicidad

loading