Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
3. PRODUCT ASSEMBLY
General assembly instructions
-
If you hang the fan on a hook, the latter must withstand at least 100 kg.
-
To prevent personal injury and damage, make sure that the location where the
appliance is going to be installed allows a 2.3-metre clearance from the blades to
the floor and a 76-cm clearance from the blades to any wall or object. Fig. 2
-
Make sure that the building structure can hold the full weight of the fan.
-
This fan can be installed on a normal or vaulted ceiling with a downrod. The
hanging length can be extended by using a longer downrod.
Assembling the fan based on ceiling type (Fig. 3):
1.
Normal ceilings
2.
Sloped ceilings (might require a longer downrod, not included)
3.
Wooden ceiling. Fig. 4
4.
Concrete ceiling. Fig. 5
Warning
To avoid electric shocks, turn the household power supply off before installing the
ceiling fan.
To assemble this ceiling fan, follow the steps below (Fig. 3-12):
1.
Remove the lower and upper pins from the downrod and release the hanging
ball at the top of the rod.
2.
Pass the wiring from the main body through the downrod.
3.
Attach the downrod to the main body by inserting the pin through the downrod
and the main-body attachment. Tighten the screws provided on the main-body
attachment to properly secure the downrod.
4.
Remove the 4 screws that fix the upper canopy and the installation bracket.
Insert the upper canopy through the downrod.
5.
Insert the pin through the pin holes located on the upper end of the downrod.
Once inserted, slide the hanging ball upward to the upper end of the downrod
and fix it with one of the screws provided.
6.
Make sure the pin fits in the slots located inside the hanging ball before screwing
it.
7.
Mark the centre of the installation bracket and use both self-tapping screws
provided with their corresponding washers and pressure washers to fix the
installation bracket to a wooden ceiling.
Warning
Self-tapping screws are only suitable for wooden ceilings. In case of installing the
32
V415 STEEL
Publicidad
