Melchioni Family BIANCA Manual De Instrucciones página 13

F = USB-C charging cable
G = Battery charger
5. USE
Battery charging: The blender is supplied with a not fully charged battery: for best performance it
is advisable to fully charge it before use. Recharging is carried out, strictly with speed selector in
position 0, connecting the charging cable to the appropriate socket provided with the charger, then
connecting the USB-C connector to the charging socket located on the side of the motor body,
taking care to disconnect and slightly move the protective rubber gasket. The insertion must be
carried out gently and thoroughly, until a click is heard in correspondence with the total insertion;
the connector is reversible, therefore it can also be inserted upside down. Once you have verified
the correct insertion of the plug, insert the charger into the wall socket and check that the recharge
starts with the sequential lighting of the LEDs of the indicator, with a number of LEDs gradually
increasing until fully recharged, that is when all the LEDs are on steady. This operation must be
performed every time the charging indicator lights up with a single LED; the charging time is
approximately 4 hours. When charging is complete, disconnect the USB cable from the motor body
and the charger from the wall socket and replace the rubber gasket on the charging connector.
During recharging, the start of rotation is electronically prevented.
Whisks application: Before first use, it is advisable to wash the whisks with normal dish detergent:
avoid washing in the dishwasher. Before use, the whisks must be connected to the motor body:
insert the kingpin of the first whip into one of the two holes on the lower part of the motor body.
Rotate the whip by pressing it towards the motor body, until you hear a further insertion with the
relative double click; carry out the same operations with the second whip. The blender is ready for
use.
Whisks disconnection: The whips are removed by gripping the mixer with the selector in position 0
and pressing the eject button located above the selector itself: the whips will be automatically
ejected. Pay attention that the whisks, when ejected, cannot fall into uncontrollable areas, creating
situations of potential danger or damage. During rotation, pressing the eject button is mechanically
prevented.
Food preparation: The food material must have a fluid consistency, in order to avoid that the
operation is difficult or that the engine can be damaged; the treatment of too dense material will
be difficult, ineffective and potentially dangerous, also due to the excessive torsion that must be
12