Melchioni Family BIANCA Manual De Instrucciones página 14

physically opposed by the user. It is advisable to slightly hydrate the food if it is too dry, compatibly
with the expected result. Avoid overloading the container in which you intend to perform the
mince, in order to prevent it from overflowing with rotation.
Using the blender: The appliance must be strictly started only if immersed in the bowl containing
the food material: operation in free air must be avoided. To start the operation, move the selector
progressively from position 1 to 5, alternating each speed change by a few seconds, in order to
make the rotation more docile and manageable, up to the ideal speed for the preparation in
progress. To obtain the best result, it is advisable to keep the blender at a distance of a few
millimeters from the bottom of the container and favor a circular movement around its perimeter,
as well as tilt it slightly to facilitate the blending of the parts; lifting and slightly re-immersing the
blender in the bowl can be further useful. Ensure at least ten minutes of shutdown after three
minutes of continuous operation, in order to ensure the cooling of the moving parts: this
precaution avoids damage and improves the reliability and life of the appliance. Avoid contact of
any object unrelated to the food material or part of the body with the moving parts.
At the end of use: Disconnect the whips as described above and wash them as soon as possible, in
order to prevent the food material from forming encrustations that are difficult to remove: use
running water and, if necessary, common degreasing liquid soap for dishes. During cleaning it is
always advisable to wear kitchen gloves; do not wash in the dishwasher. The motor body can be
cleaned with a simple damp cloth; in all cases avoid immersing it or putting it under running water
and wait for it to dry completely before putting it back into service.
6. PROBLEMI E POSSIBILI SOLUZIONI
Problem
The blender does not start
The blender stops suddenly
The blender does not mix
effectively
The whips do not disengage
Any further cases of malfunction may in any case occur, as well as those indicated could depend on
other causes and require further treatments; in these cases, however, it is not possible to work
effectively for the solution and it is necessary to contact an authorized service center.
Possible cause
The battery is dead
The blender has not started
Excessive effort was required
from the engine
The selected rotation speed is
too low
The food is too dry
The release button was not
pressed hard enough
The whips remain stuck in the
motor body
13
Probable solution
Recharge the battery as
described in chap. 5
Start the mixer by carefully
following the instructions in
chap. 5
Decrease the density of the
food material, move the
selector to 0 and start again
Increase the rotation speed as
indicated in chap. 5
Increase the food hydration
Press the button harder; it
may be helpful to lean on a
flat, solid surface
Exert a slight pull on the whips
to extract them