Derby 85897E-BAY Instrucciones De Montaje página 9

Granite base without
roller system – assembly
instructions and user
manual
Carefully read through the
complete assembly instruc-
tions and user manual, par-
ticularly the safety instructions. Failure to
heed these safety instructions may result
in severe injury or damage to the granite
base. Hold onto the assembly instruc-
tions and user manual for future refer-
ence or in order to pass it on to third par-
ties.
Your safety
Please observe the following
safety instructions. The manu-
facturer is not liable for damage
as the result of failure to comply.
The granite base is not a children's toy.
Children could crush their fingers or feet.
The granite base is very heavy. It must
always be transported by 2 persons.
Never leave the granite base unattend-
ed when in an upright position – if it falls
over, it could result in severe injury.
Keep in mind that, depending on wind in-
tensity and diameter of the sun shade,
this granite base may also be too "light."
Make sure that the sun shade is closed
in the event of incoming wind.
For 85897KBN:
Only use the granite base on balco-
nies whose railings are stable enough to
withstand the forces exerted by the sun
shade and the granite base. Have a pro-
fessional evaluate the situation.
Always position the granite base right
next to the balcony railing and always
secure it with the premounted hook and
loop strip. Otherwise, the shade pole
will not be sufficiently secure and using
it may result in injury to persons and/or
damage to property.
Proper use
Depending on the model, the gran-
ite base is suitable as a stand for sun
shades with a pole diameter of no more
than 60 mm.
The granite base is intended for domes-
tic use only. It is not suitable for commer-
cial use.
Before you use the granite base, please
first carefully read through the safety in-
structions. Only in this way, will you be
able to use the granite base in a safe and
reliable manner.
It is imperative that you observe the na-
tional regulations in force in your country
which also apply in addition to the regu-
lations in this assembly instructions and
user manual.
Mounting the stand tube
You will need:
– 1 socket wrench (not included in the
package contents)
– The help of 1 person
Please note!
– The granite base is very heavy. Al-
ways have a second person hold the
granite base in place during installa-
tion.
1. Lift the granite base and place it up-
right on one of its lateral surfaces.
2. Put the small rubber disc 1, the snap
ring 2 and the shim 3 over the screw 4.
3. Run the screw 4 through the granite
base from the bottom (see Figure A).
4. Push the large rubber disc 5 on the
top of the granite base over the thread
of the screw 4 (see Figure A).
5. Screw the threaded hole of the stand
tube 6 onto the screw 4 and tighten it.
6. Carefully tilt the granite base back to
the ground.
GB
9