Publicidad
Idiomas disponibles
Idiomas disponibles
17T Series Installation
Showerhead and Tub Spout Installation
2
A.
FOR TUB SPOUT INSTALLATION:
Refer to the installation instructions supplied with your spout. Do not connect deck mount
spouts to in-wall valves. Do not use hand showers connected in lieu of a tub spout to a
tub/shower valve. Do not use PEX tubing for tub spout drop.
B-1
B-2
B-3
2
1
3
1
2
1
1
3
2
FOR SHOWERHEAD INSTALLATION:
Apply Teflon
®
both ends of the shower arm (1). To
prevent damage to finish on shower arm,
insert wall end of shower arm into shower
flange (2) before screwing arm into riser
connection.
Thread showerhead (3) onto shower arm.
Do not overtighten showerhead.
Slip-On Installation
The copper tube (1) must be 1/2" nominal
copper. Important: If it is necessary to cut
the copper tube, the end must be cham-
fered free of burrs to prevent cutting or
nicking O-ring inside the spout. Slide spout
over copper tube flush with the finished tub
or wall surface. Tighten set screw (2), but
do not overtighten.
Iron Pipe Installation
Install threaded pipe nipple (1) to extend
past finished wall. Apply Teflon
threads on pipe nipple and screw on
tub spout.
Copper Sweat Installation
Remove O-ring (1) from adapter (2). Solder
adapter to tube taking care to keep solder
away from O-ring groove. CAUTION: NO
SOLDER PERMITTED ON OUTSIDE
DIAMETER OF ADAPTER ADJACENT
TO O-RING GROOVE. Cut off tube (3) and
replace O-ring on groove of brass adapter.
Thread tub/spout onto adapter, taking care
not to damage O-ring, and hand tighten
until spout is firmly against finished wall
and all slack is taken up behind wall.
14
tape to pipe threads on
tape to
®
Publicidad
