YATO YT-82458 Manual Original página 11

EN
If an active soldering iron remains stationary in the stand, it will switch to the sleep mode after about 10 minutes. This will cool the
tip to 200 C. The display will show the messages "SLP" and "200", alternately. Switching from the sleep mode to the operating
O
mode can be done in three ways. Lift the soldering iron off the stand and the temperature will automatically return to the previously
set value. Press any button for temperature change or to turn off and on the part of the soldering station responsible for providing
power supply to the soldering iron.
If the "S-E" message is displayed on the screen, it indicates that the temperature sensor is faulty or there is a short cut in the
soldering iron's circuit. This message can also be displayed, if the temperature exceeds the operating temperature indicated in
the table or if the soldering iron is not properly connected. In this case, turn the station off , allow the soldering iron to cool down
completely, check the connection, and restart the soldering iron. If the message remains on the screen, contact an authorised
service centre of the manufacturer.
Operating the blower
Place the blower in the holder. Use the switch to turn it on. The display will show „---" because the blower is in the standby mode.
Set the blowing temperature, using the buttons marked with arrows, in the same manner as for the soldering iron. Grab the blower
and point the nozzle outlet towards the place of work. Adjust the airfl ow force using the knob. The higher the set value, the higher
the airfl ow speed.
Start working after the temperature has stabilised, which will be indicated by a fl ashing indicator on the display.
After fi nishing work, place the soldering iron in the holder with the nozzle pointing upwards. The device sensor will switch off the
heater and start cooling the soldering iron. When the temperature drops below 100 O C, the device will switch to the standby mode.
If you want to resume operation, lift the soldering iron from the holder, and the device will automatically restore the preset temper-
ature. If the work will not be resumed, switch off the station with the power switch.
Caution! It is recommended to set the lowest temperature suffi cient for operation and the highest airfl ow speed. These parameters
will prolong the life of both the station and its electronic components.
If the "S-E" message is displayed on the screen, it indicates that the heater is damaged and the temperature has dropped below
50 C. If that is the case, contact an authorised service centre of the manufacturer.
O
MAINTENANCE AND STORAGE
After fi nishing work, clean the tip using a damp sponge and then place the soldering iron in the stand, switch off the soldering
station with the power switch and leave it until all elements have cooled down completely. Allow the blower to cool down by itself,
turn the station off with the switch and leave it until all the elements have cooled down completely. Disconnect the station from the
power supply by pulling the power cord plug out of the power socket.
Clean the station housing and soldering iron holder with a soft cloth slightly dampened with water, then dry it.
Check the tip condition; if any defects, damage, or changes in shape are observed, replace the tip with a new one. Unscrew the
clamping sleeve by rotating the ring located near the soldering iron handle. Then pull out of the sleeve the old tip and replace it
with a new one. Mount the sleeve with the tip to the soldering iron.
The sponge for cleaning the tip should be cleaned under a jet of lukewarm water. Replace excessively soiled or damaged sponges
with new ones.
Store the product disconnected from the power supply in places not accessible to unauthorised persons, especially children. The
storage place should protect against dust, moisture, precipitation, excessive heat, and provide adequate ventilation to prevent
condensation of water vapour.
O R I G I N A L I N S T R U C T I O N S
11