MONDOLUX MS04 Manual De Instrucciones

Venice Mini
SPOTLIGHT
EN
Warnings
 The safety and compliance of this fitting are not assured unless the following instructions are adhered to.
Please retain these instructions for future reference.
 Always turn the mains OFF prior to installation. See Picture below.
 The system is IEC 60570:2003+AMD1:2017 certified and Installation must be carried out by a licensed
electrician
 Risk of Electric Shock: Prior to installation or maintenance, disconnect the fitting from power supply and other
control wiring. Faulty cables and wiring need to be replaced by manufacturer only.
 Risk of Burns: When in use, the fitting's surface may reach high temperatures and can cause skin burns. It is
recommended to install the fitting out of reach to avoid any physical contact.
 It is recommended to always wear safety glasses and gloves during installation.
 For safety reasons please keep children away from installation site.
 Please follow below instructions for disposal in accordance with EU Directive WEEE (Waste Electrical and
Electronic Equipment):
• Fittings cannot be disposed alongside other household waste.
• Remove the lamp/ battery for decommissioning (if applicable)
• Send them to nearest WEEE collection center.
 For further inquiries, please contact Mondolux at https://www.mondolux.com.au/
FR
Avertissements
 La sécurité et la conformité de ce raccord ne sont pas assurées si les instructions suivantes ne sont pas
respectées. Veuillez conserver ces instructions pour référence future.
 Coupez toujours l'alimentation secteur avant l'installation. Voir l'image ci-dessous.
 Le système est certifié IEC 60570:2003+AMD1:2017 et l'installation doit être effectuée par un électricien agréé
 Risque de choc électrique : avant l'installation ou l'entretien, débranchez le raccord de l'alimentation électrique
et des autres câbles de commande. Les câbles et le câblage défectueux doivent être remplacés uniquement
par le fabricant.
Product Code MS04
Installation Manual
mondolux.com