Beamz DMX440 Manual De Instrucciones página 9

Operation
1. Programming:
Hold on (3) PROG then push the (1) PROG1-4 which you want to programming ， the
corresponding led will flash. It means the units enter programming. Exit programming operation
is same do.
In programming, you can adjust output for each channel by (12), if you adjust them well you could
push (3) PROG to save and all led will flash three times and the step has been saved。
Note: if you don't delete fore steps it will add step. When the memory is full you can't save you
want and the led will not flash.
Delete a program ：
2.
Hold on (3) PROG then push the (1) PROG1-4 one of them. You have enter programming.
Now you can hold on the (9) Tap Sync then you can push one of (1) PROG 1-4 which one you
want to delete. If you push all led will flash 5 times and the corresponding program has been
deleted.
Note: it will delete all steps in this program.
3. Running chase or program:
Push (6) chase 1-4 or (1) PROG 1-4, the corresponding led will light up. You can select running
in auto or sound by (2) SC/CH.
You can select one of them or you can select more of them. But the running order will be
Chase1》 Chase2》 Chase3》 Chase4 》 Program1》 Program2》 Program3》 Program4》.
If the program is empty it will jump the program.