Publicidad
STEP 20
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER. FOLLOW
THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET PROVIDED WITH THIS
PRODUCT.
OPTION 1: Attachment into a wall stud (preferred
method)
Using a stud finder, locate a stud in the wall. Place
your unit against the wall, with the safety bracket
aligned in this location. To make driving the screw
easier, you can drill a 1/8" diameter pilot hole
(3mm) through the safety bracket into the stud.
Drive the screw through the safety bracket into the
wall stud. Tighten the screw that was not fully
tightened in step 8.
OPTION 2: Attachment into drywall
Locate your unit where desired against a wall and
mark the wall through the safety bracket, then
move your unit aside. Drill a 3/16" diameter hole
(5mm) into the wallboard. Tap the wall anchor into
the hole until it is flush. Move your unit into
location and fasten the wall bracket to the wall
anchor with the screw. Tighten the screw that was
not fully tightened in step 8.
12c
12d
(x1)
#A84050
12d
28
For Masonry, Concrete, or other
wall materials:
Consult your local hardware store
for appropriate anchors to securely
attach the safety bracket.
hole
stud
wallboard
12c
Publicidad
