Kenwood KAC-8151D Manual De Instrucciones página 4

Controls / Indicator
1 EXPANDER switch
When this switch is turned ON the dynamic
range is increased.
2 LPF (Low-Pass Filter)
FREQUENCY control
This control adjusts the frequency band
output from this unit.
3 INFRASONIC switch
Ultralow frequencies that cannot be
reproduced even by a subwoofer speaker
do not become sound but become
unnecessary oscillations, which affect the
sound by causing distortion, etc. Setting
this switch to "15 Hz" or "25 Hz" cuts the
frequencies below the respective
frequency.
This improves the reproduction
performance of the speakers by eliminating
unnecessary oscillations which will not
become sound.
4 BASS BOOST switch
Sets the boost level for bass control.
• 12dB position:
BASS BOOST is +12 dB.
• KAC-8101D: OFF position:
BASS BOOST is OFF.
• KAC-8151D: OFF(REMOTE) position:
Can be set from the Remote Controller.
NOTE
If you have disconnected the Remote
Controller, the BASS BOOST is turned OFF.
4
English
1 2 3 4
5 INPUT SENSITIVITY control
Set this control according to the pre-output
level of the center unit connected with this
unit, or to the maximum power output of
the genuine-accessory car stereo.
Use the diagram on the right as a guide.
NOTE
For the pre-output level or the maximum
power output, refer to the "Specifications"
in the instruction manual of the center unit.
6 Remote controler control (KAC-
8151D only)
When the "BASS BOOST" switch is in the
"OFF (REMOTE)" position, control the Bass
Boost level from the Remote Controller.
• OFF position:
BASS BOOST is OFF.
• +6/+9/+12 position:
Boost the bass sound by +6 dB, +9 dB and
+12 dB, respectively.
(W)
40
20
10
5